Matters needing attention in operation of internal mixer in small laboratory

2020-01-15

1576751848212455.jpg

Hermetic sizing machine, also known as internal mixer, kneading machine, mainly used for rubber, plastic and mixing. Next, the treasure instrument to tell us about the use of laboratory mixer notes. 1. Check the insulation effect of each circuit of the airtight glue-scouring machine regularly, and pay attention to the warning on the warning board of the machine at all times. 2. Do not use your hands or iron bars to handle the blockage in the moving parts and the mixing chamber. Use a plastic bar to handle it carefully. Please be careful not to be scalded when touching the high-temperature part of the airtight type glue-training machine. 4. When a leak or seal ring screams, first loosen the four nuts evenly and then screw some more in, then add some material oil or engine oil to the Rotor gap in the Mixing Chamber, then leave to idle for 3 minutes, lightly tap the Rim of the gland of the seal ring with a hammer on the edge of the spring, and adjust the tightness of the individual springs if powder is leaking, if the Sealing Ring Gland and Sealing Chamber side plate tank is close to the inner seal ring is now worn, need to replace, replace the method of sealing ring can be seen in the manual or Electrical Union Division I technical staff. 5, special attention: check each gear oil, oil, butter oil level and lubrication state before starting up every day, pay attention to is not less than half of the oil level of the Triplet Oil Cup. 6, Airtight type glue machine presents a problem, stop the action of the machine within a time, unrelated personnel can not do any action privately, notice and wait for your machine repair personnel to see maintenance. Compared with the laboratory mixer, the internal mixer uses the regular shrinkage of the internal impeller to produce the shearing force when the impeller moves relative motion. It does not need manual operation and Saves Labor.

share to